Paverpol is non-toxic	The textiles and decoration hardener par excellence! Dip natural materials, such as textiles, in Paverpol. Drape or wrap the material around a wire figure or other armature and leave it to dry. Paverpol dries fast, but slowly enough to allow plenty of working time. After it has hardened, you have created a beautiful decoration or sculpture, which can be used indoors as well as outdoors. It is also possible to combine Paverpol with paper, silk, chamois leather, self-hardening clay, polystyrene foam, dried flowers, wood, plaster, pottery, etc. One litre- is generally enough product for 3 or 4 small figurines, 11 x 14” memory boards or wall sculptures, up to 2- 14” figurines, or one large (up to 24”) garden statue.
LARGE (1000 Gram, 1 Litre) in Transparent, Terra Cotta	1000 gram (1 liter) Paverpol Transparent (shown in the middle sized container above) Price $34.95 plus exact shipping.   Add to Cart 1000 Gram (1 Liter) Paverpol Terra Cotta  $33.95 plus exact shipping (I can fit TWO of these in a Flat Rate Box in the U.S.)   Add to Cart (3 left, I will no longer be stocking this so grab it now while it's in stock)
500 gram (1/2 liter) in Transparent	500 gram (1/2 liter) Paverpol Transparent  Price $23.50 plus exact shipping   Add to Cart (Transparent)
250 gram (1/4 liter) These now have a small tip at the top, great for control-usage!	250 Gram (1/4 liter) Paverpol Transparent $15.95 plus postage   Add to Cart
	Pavercolor 40 ml (about 2 ounces) This is a pigment powder that can be mixed with Paverpol to change the transparent Paverpol into the color of your choice. The powders can be combined to make custom colors. Mix the powder with a small amount of water before you add it to Paverpol. This prevents it from becoming lumpy. The Pavercolor metallic colors will loose their lustre when mixed with Paverpol; however, the lustre can be retained by brushing the dried piece of work with the Pavercolor metallic color mixed with Josefine gloss varnish. All Pavercolors can be mixed with water to obtain water paint. However, this technique can only be used for indoor pieces of work. For outdoor objects (i.e. garden sculptures) you can mix Pavercolors with Josefine gloss varnish. It is then a proper outdoor paint that can be used for painting, brushing and adding patina effects. These are postpaid $9.25 each (in the U.S.) Brique Stone Red  Add to Cart Siena Add to Cart Sea Blue   Add to Cart Metallic Pavercolor (below) are $16.95 PPD Metallic Mother of Pearl Add to Cart Metallic Bronze Add to Cart Metallic Copper Add to Cart
	Pavercotton 50 gram package A 100 % cotton fiber. When dipped in the Paverpol and squeezed out well, it can be used to make hair/wigs for the Paverpol figurines. It can also be used to make creative dishes. Project idea: Cover a dish with cling film and put the Pavercotton tuffs dipped in Paverpol on one side of the cling film. The dish is only to be used as a mould, and will not be damaged. After it has dried and hardened (for at least one week) you can take the dish off. The side that was covered by plastic will still need to dry. You have to be patient for this, but if you do, you will end up with a unique cotton dish which can be used as a creative decorative bowl. $9.25 postpaid in the U.S. or Canada Add to Cart
	Stockinette Stockinette is a very stretchy, open-weave knit used as decoration to clothe figurines. Once the Stockinette is dipped in Paverpol, it stretches in length and will become twice as long. It is a highly decorative piece of textile, which can be used endlessly for decorating or draping. Stockinette can be coloured with Paverpol mixed with Pavercolor. Available in bags of 80 x 100 cm $10.95 ppd in the U.S. or Canada Add to Cart
	From T-shirt to Garden Statue book by Jossy de Roode Suddenly there is a product that makes you lose your senses! That is what happened to me when I discovered Paverpol. I had made earlier pieces using other hardeners, but not one of them became as hard or dried as transparently as Paverpol did. I began some major experimenting and became increasingly enthusiastic.  Especially because I also discovered that Paverpol withstands exterior conditions and even extreme frost.  The foundation of my idea to use this to make a garden statue was laid and I set to work. Paverpol can be combined with natural material excellently. It is an environmentally friendly water based product so one can work with it using bare hands. Even children!  I cut strips and rags from an old cotton t-shirt and I made a frame using a few pieces of electrical wire. I soaked the strips and rags in the Paverpol and wrapped them around the frame, and this gave rise to a statue. In order to place it outside, this had to be weighted or it would blow right out of the garden with every gust of wind. Using Paverpol, I stuck the statue to a concrete pillar and to my surprise, a few days later I could lift the statue by its head with the concrete pillar stuck to it very firmly! Therefore, you need not make any complicated constructions to make a sitting statue. As Paverpol dries quickly, you can make a statue in one day. Painted and all! The complete hardening will still take a few days, but that happens by itself. By now I have convinced hundreds of students and I hope you will join their number. Have fun making different pieces and working with Paverpol. $17.50 ppd in the U.S. Add to Cart
	Armatures (wire skeletons) 8" $6.00 postpaid in the U.S. and Canada/Mexico  Add to Cart 14" $7.00 postpaid in the U.S. and Canada/Mexico  Add to Cart
	Fiber Mache Mask (oh, this looks like fun to play with!) Approx. 8" $9.50 postpaid in the U.S.    Add to Cart  (this has to ship in a box)